 |
| CAUTION: To insure proper assembly, tubing MUST be fully inserted into the fitting body to the tube stop. |
INSTALLATION INSTRUCTIONS FOR JACO
TUBE FITTINGS
1. Cut the
tubing end squarely and remove the internal and external burrs.
2.
Insert the tubing through the back of the nut all the way through the
nut assembly to the tube stop in the fitting body (see illustration). If
the tubing does not enter the nut easily, loosen the nut one turn and
then insert the tubing all the way to the tube stop in the fitting body.
3. Turn
the nut hand tight.
4.
Wrench tighten the nut 1-1/2 to 2 turns.
5. All
nuts must be re-tightened when the system reaches projected operating
temperature.
NOTE: It is not necessary to disassemble this fitting for
application. Merely insert tubing to stop and tighten seal.
NOTE: Squeaking sound when tightening nut is normal. For pipe
threaded connections, Teflon Tape* must be used.
* Dupont's Reg. T.M. Patent 1983 |
Close Window
|
|
Home | Products | Shopping Info | Valve Selection Guide | Technical Resources | Contacts | About Us
Disclaimer | Terms and Conditions of Sale | Security | Privacy | Shopping Cart | Checkout
Advertising | Website Design & Hosting | Investors | Suggestion Box | Employment |
The Valve Shop, 1862 Blue Bonnet Place, Encinitas, CA 92024
Tel. (760) 479-1477, Fax (760) 479-1497
Toll Free 1-888-358-0030Copyright © 2000 - 2006 The Valve Shop. All rights reserved.
 |
High quality, heavy duty, corrosion resistant PVC float valves.